Advertisement
BT Accord 30 manual pdm
15/6/04
Troubleshooting
Problem
Items to check
• Check if battery power is low and replace all batteries
There is no response
if required
from the unit
• Check if the batteries are inserted correctly
• Make sure the on/off is switched to on
• Check if the configuration switch is properly selected
• Check that the volume control and mute button are
adjusted properly
• Check that the headset/handset and the cable
connecting the BT Accord 30 to the telephone are
properly connected
• Check if the telephone/computer switch (8) is set
I cannot hear any dial
to 'telephone'
tone or my caller
• Re-check your configuration settings (pages 4-5). Try
speaking to me
other positions until you can hear a dial tone.
• Make sure the mute button is not pressed down
My caller cannot hear
• Use the screwdriver to see if the microphone
me at all or cannot
sensitivity (6) is set too low
hear me very well
• Try to select the proper settings with the configuration
switch
I hear my voice too
• Use the screwdriver to see if the microphone
loud and there is a
sensitivity (6) is set too high
squealing sound
• Take a look at the connection on your computer where
When using with my
the cables connect with the BT Accord 30 amplifier.
computer, the sound
There should be 3 jacks (line in, line out, and speaker)
is too loud even
• Make sure the line out cable from the amplifier is
though the volume is
connected to the line in jack of the computer
set at minimum
• Make sure that the line in cable from the amplifier is
connected to the line out jack of the computer and
NOT the speaker jack
10
5:38 pm
Page 10
Information!
For your safety we advise that you keep this headset and its components away
from any liquids. Do not attempt to effect repairs yourself; seek qualified advice.
Only use an approved mains adaptor as damage may occur if an incorrect adaptor
is used. Always operate at a safe volume level to protect your hearing. Take a
break after using the headset for any length of time.
Specifications
Standard operating voltage
Operating Current (Max)
Standby Current
Standby Mode Activation
Amplifier Gain
Battery
Adapter DC input
Adapter not included
Standards Approval
A copy of the Declaration of Conformity for this product can be found at
www.easidirect.co.uk
3V DC
9 mA
200 µA
2 ~ 3 min. without signal
- Speaker
13 dB (Max)
- Microphone
30 dB (Max)
2 x "AA"
6V ~ 9V DC
11
Advertisement
