Advertisement
BT Accord 30 manual pdm
15/6/04
Microphone sensitivity control
The BT Accord 30 allows you to adjust the outgoing sound volume, and the high
and low frequencies associated with it. To fine tune the transmission volume, place
a call and talk as usual using the headset. Slowly rotate the microphone
sensitivity control (6) with the small screwdriver pin provided until the desired
level is reached. The person talking to you should be able to tell you when the
optimum sound and tone level is reached. Once this is set, there should be no
need to make further adjustments in the future.
Caution: Be careful when you adjust the volume control, as rotating the
volume to maximum setting may cause the headset to "squeal". Reduce the
volume and the "squealing" will disappear, but continuous over-turning of the
control may cause damage to the unit.
8
5:38 pm
Page 8
Operation
Making calls using the headset
•
•
•
•
Receiving calls using the headset
•
•
•
•
Using the headset with a computer
•
•
•
•
BT Accord Helpline
If, after following these instructions and carefully checking the settings, you require
assistance with your BT Accord headset please call 0871 200 2276 between
9.00am and 5.30pm Monday to Friday (except public holidays). Calls are charged
at national rate.
Switch to telephone position through the telephone/computer selection
switch (8).
Make sure the headset position is selected on the headset/handset
selection switch (11).
Lift up the handset from its cradle and place it "off-hook", you should now hear
a dial tone and may dial the number you require.
After finishing a call, return the handset to its cradle as usual.
Switch to telephone position through the telephone/computer selection
switch (8).
Make sure the headset position is selected on the headset/handset
selection switch (11).
Lift up the handset from its cradle and place it "off-hook", you should now hear
your caller and may speak.
After finishing a call, return the handset to its cradle as usual.
Switch to computer position through the telephone/computer selection
switch (8).
Select the headset position from the headset/handset selection switch
(11).
When a telephone call comes in or you want to make a call while working on
your computer, simply switch to telephone position (8) and lift the handset.
When you have finished your call simply place the handset back on its cradle
and switch back to computer (8) to return to your existing computer work.
9
Advertisement
