Power Management; Automatic Configuration And Power Interface (Acpi) Bios; Automatic Power-On Features - Lenovo ThinkCentre A70z Hardware Maintenance Manual

Hardware maintenance manual for thinkcentre a70z
Hide thumbs Also See for ThinkCentre A70z:
Table of Contents

Advertisement

3. The computer will automatically begin recovering the BIOS. During this time, you will see a screen
indicating that Flash recovery has started. After the update session completes, the computer
automatically reboots.
4. Remove the BIOS flash diskette from the diskette drive.

Power management

Power management reduces the power consumption of certain components of the computer such as the
system power supply, processor, hard disk drives, and some monitors.

Automatic configuration and power interface (ACPI) BIOS

Being an ACPI BIOS system, the operating system is allowed to control the power management features
of the computer and the setting for Advanced Power Management (APM) BIOS mode is ignored. Not
all operating systems support ACPI BIOS mode.

Automatic Power-On features

The Automatic Power-On features within the Power Management menu allow you to enable and disable
features that turn on the computer automatically.
• Serial Port A Ring Detect: With this feature set to Enabled and an external modem connected to serial
port (COM1), the computer will turn on automatically when a ring is detected on the modem.
• PCI Modem Ring Detect: With this feature set to Enabled, the computer will turn on automatically
when a ring is detected on the internal modem.
• PCI Wake Up: This feature allows PCI cards that support this capability to wake the system.
• Wake Up on Alarm: You can specify a date and time at which the computer will be turned on
automatically. This can be either a single event or a daily event.
• Wake on LAN: If the computer has a properly configured token-ring or Ethernet LAN adapter card that is
Wake on LAN-enabled and there is remote network management software, you can use the Wake on LAN
feature. When you set Wake on LAN to Enabled, the computer will turn on when it receives a specific
signal from another computer on the local area network (LAN).
.
Chapter 10
Additional Service Information
181

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents