Advertisement
tor dry and restart it.Place the food items back inside but
wait until the refrigerator is cold before making ice cubes.
CLEANING THE REFRIGERATOR
Clean the inside of the refrigerator regularly to keep it fresh
and hygienic.
Soak a cloth in a solution consisting of a teaspoon of bicar-
bonate of soda to half a litre of warm water. Wring out the
cloth and use it to clean the interior of the refrigerator and
its fittings.
Never use detergents, scouring powder, strongly scented
products or wax polish to clean the interior of the refrigera-
tor as they may damage the surfaces and leave a strong
odour.
The exterior of the refrigerator should be wiped clean now
and again, using a damp cloth and a small quantity of deter-
gent. But not the door gasket, which should only be cleaned
with soap and water and then thoroughly dried.
The cooling unit behind the refrigerator should be cleaned
with a brush from time to time, but make sure that the
re-frigerator is switched off when doing this.
TURNING OFF THE REFRIGERATOR
If the refrigerator is not to be used for some time:
Shut off any on-board valve in the gas line to the refrige-
rator.
Set the electric switch (A) to 0.
Set the gas valve (D) to
Empty the refrigerator. Defrost and clean it as described
earlier. Leave the doors of the refrigerator and the frozen
food compartment ajar. Use the travel catch to hold in
this position.
IF THE `FRIDGE FAILS TO WORK
Check the following points before calling the service:
1. That the STARTING THE REFRIGERATOR instructions
have been followed.
2. The refrigerator is level.
3. If it is possible to start the refrigerator on any of the
connected sources of energy.
4. If the refrigerator fails to work on gas, check:
That the gas bottle is not empty.
That all LP-gas valves are open.
5. If the refrigerator fails to work on 230 V, check:
That the 230 V supply is connected to the refrigerator.
That the fuse is intact.
If the refrigerator is not cold enough it may be because:
1. The ventilation of the cooling unit is inadequate e.g. vent
grille in table top obstructed
2. The evaporator is frosted up.
3. The temperature control setting is incorrect.
4. The gas pressure is incorrect - check the pressure regu-
lator at the gas container.
5. The ambient temperature is too high.
6. To much food is loaded at one time.
7. The door is not properly closed or the magnetic door seal
is defective.
8. More than one source of energy is used at one time.
.
If the refrigerator still does not work properly, call a service
technician.
The sealed cooling system must not be opened, since it
is under high pressure.
MAINTENANCE
Concerning gas- and electric installations, only authorized
experts are allowed to carry out maintenance and repair
works. Besides, it is recommendable to contact an authori-
zed service if it comes to repair works.
According to the valid regulations G607 of DVGW, the gas
installation as well as the connect flue oulets are to be
checked every two years by an expert (this has to be
arranged by the person responsible).
SOME USEFUL HINTS
Make sure that:
Defrosting is carried out periodically.
The refrigerator is clean and dry with the door left open
when it is not to be used for some time.
Liquids or items with a strong odour are well packa-ged.
The ventilation of the cooling unit is unobstructed
Only one mode of operation at a time is used to run the
refrigerator.
GUARANTEE
The refrigerator is guaranteed for one full year on condition
that it is used in a correct manner and in accordance with
these operating and installation in-structions.
TECHNICAL DATA S105 G, S105 GE
Overall dimensions, refrigerator
Height
. . . . . . . . . . . . . . . . . . . . . . . . . 811 mm
Width
. . . . . . . . . . . . . . . . . . . . . . . . . 526 mm
Depth
. . . . . . . . . . . . . . . . . . . . . . . . . 544 mm
Capacity
gross
. . . . . . . . . . . . . . . . . . . . . . . . . . . 103 lit
net
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 91 lit
frozen food compt . . . . . . . . . . . . . . . . . . . 12 lit
Weight (whithout packaging) . . . . . . . . . . . . . . 33 kg
Electrical data
Input 230 V . . . . . . . . . . . . . . . . . . . . . 125 watt
Energy consumption/24 hours . . . . .2,7 kWh
Lp gas data
Input
. . . . . . . . . . . . . . . . . . . . . . . . 232 watt
ditto, low flame . . . . . . . . . . . . . . . . . . 105 watt
Energy consumption/24 hours . . . . . .0,27 kg
Cooling medium . . . . . . . . . . . . . Ammonia or R 717
INSTALLATION INSTRUCTIONS
REPOSITIONING THE HINGES
The door hinges can be moved to the opposite side in the
following way:
Screw out the lower hinge pin
Remove the door from the upper hinge pin
Remove the upper hinge pin and assemble it to the
opposing holder
Fit the door on the pin and assembly the lower pin to the
new side
7
Advertisement
