Side by side and top mount refrigerators (64 pages)
Summary of Contents for Electrolux 2573-4 KA
Page 1
Öko Santo Super 2573-4 KA Fridge Operating Instructions...
Page 2
Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance.
Intended use • The refrigerator is intended for use in the home. It is suitable for the cooling. If the appliance is used for purposes other than those inten- ded or used incorrectly, no liability can be accepted by the manu- facturer for any damage that may be caused.
Page 5
• Do not touch frozen food with wet hands. Your hands could freeze to the food. • Do not operate any electrical appliances in the refrigerator/freezer (e.g. electric ice cream makers, mixers etc.). • Before cleaning the appliance, always switch off the appliance and unplug it, or pull the house fuse or switch off the circuit breaker.
Disposal Appliance Packaging Information All materials are environmentally sound! They can be dumped or bur- ned at an incinerating plant without danger! About the materials: The plastics can be recycled and are identified as follows: >PE< for polyethylene, e.g. the outer covering and the bags in the interior.
If these clearances cannot be maintained a heat insulating pad is required between the cooker and the refrigeration appliance. If the refrigeration appliance is installed next to another refrigerator or freezer a clearance of 5 cm at the sides is required, in order to pre- vent the formation of condensation on the outside of the appliance.
Your appliance needs air For safety reasons, minimum ven- tilationmust be as shown Fig. Attention: keep ventilation ope- nings clear of obstruction; Rear spacers In the bag with the documentation, there are two spacers which must be fitted. slacken the screws and insert the spacer under the screw head, then re-tighten the screws.
Page 9
Remove the centre hinge and slide the top door off pin (D); unscrew pin (D) and refit it on the opposite side. Remove the two plugs, to reveal the holes for the hinge pivots, and remount them on the other side. Refit the top door and the centre hinge (H) on the opposite side.
Prior to Initial Start–Up • Please clean the appliance interior and all accessories prior to initial start-up (see section: “Cleaning and Care”). Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING –...
Setting „4“ (end-stop) means: Lowest temperature, (coldest set- ting). However, the exact setting should be chosen keeping in the mind that the temperature inside the refrigerator depends on: -the quantity of food stored -how often the door is opened Important! High ambient temperatures (e.g.
Interior Accessories Storage shelves • You should always slide one of the full size glass storage shelf into the lowest set of guides, above the fruit and the vegetable contai- ners, and keep it in this position. • The height of the storage shelves can be adjusted: •...
We particulary recommend that you peridically clean the defrost-water drainage outlet, located in the center of the drainage groove in the refrigerator compartment, to prevent the defrost water form overflowing on to foods stored in the com- partment. Use a special cleaner provided, which you will find...
Switching off the appliance To switch off the appliance, turn the temperature regulator to position "0". If the appliance is not going to be used for an extended period: Remove all refrigerated packages. Switch off the appliance by turning the temperature regulator to posi- tion "0".
• Do not use any abrasive cleansers. Remove the food from the refrigerator. Defrost the freezer compartment prior to cleaning (see "Defrosting" section). Switch the appliance off and remove the plug from the mains, or swit- ch off or turn out the circuit breaker or fuse.
What to do if ... Correcting Malfunctions A malfunction may be caused by only a minor fault that you can rec- tify yourself using the following instructions. Do not perform any other work on the appliance if the following information does not provide assistance in your specific case.
Press the light bulb cover as shown and slide it backwards. Change the defective light bulb. Refit the light bulb cover and the screw. Put the refrigerator back into operation. Door seal is not air tight (possibly after changing over the hinges). Appliance is not level.
Customer Service If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department. Addresses and telephone numbers are listed in the accompanying booklet "Guarantee Conditions/Customer Service Locations". Selective ordering of replacement parts can save unnecessary travel and costs.