Installing And Cleaning The Refrigerator - Electrolux EBB2802H User Manual

R600A REFRIGERANT WARNING
• This appliance contains flammable R600a refrigerant.
Avoid safety hazards by carefully installing, handling,
servicing and disposing of this appliance. If your
appliance contains R600a it will be indicated on the
rating plate inside the appliance.
• Ensure that the tubing of the refrigerant circuit is not
damaged during transportation and installation.
• In the event any damage accidentally occurs, keep the
appliance away from open fires and any devices that
produce sparks or arcs and luminaries during normal or
abnormal operation, and unplug the appliance at the
power point. Call authorized service for necessary
action and advice.
• Leaking refrigerant may ignite vent area if leak occurs.
• The room for installing appliance must be at least 1m3
per 8g of refrigerant. The amount and type of refrigerant
in the appliance can be found on the rating plate inside
the appliance.
• Do not damage the refrigerant circuit.
• Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the
type recommended by the manufacturer.
• Keep ventilation openings, in the appliance enclosure
or in the built-in structure, clear of obstruction.
• Do not use mechanical devices or other means to
accelerate the defrosting process, other than those
recommended by the manufacturer.
WARNING
• Do not use a steam cleaner. If live components come
in contact with the condensing steam, they may short
circuit or cause an electric shock.
• Do not plug the appliance into a timer fitted to the
power point.
• Do not put your appliance on an uneven surface.
• Do not store explosive substances such as aerosol cans
with flammable propellant in the appliance.
• Do not store fizzy drinks in the freezer compartment.
• Never try to repair the refrigerator on your own. Use
only a qualified or authorised service person for repairs.
• Never use electric heaters or dryers to defrost the
freezer because you can receive an aelectric shock.
Installing Your New Refrigerator
Clean the refrigerator thoroughly according to instruction,
and wipe away any dust that has accumulated during
shipping.
Check that the floor is level. If it is not then adjust the
provided levelling leg so product is level and stable.
We recommend that you let your refrigertor run for two
to three hours before you put any food in it. This will allow
you to check that it is operating properly and that
enough cool air is going to the freezer.
4
OM Refresh III_VT.indd 12 OM Refresh III_VT.indd 12
Clearance around your Top and Bottom Mount refrigerator
• Allow a minimum of 30mm clearance on both sides of the
refrigerator.
• Allow 50mm clearance at the back of the refrigerator.
• Allow a minimum of 10mm clearance above the hinge cover.
• If you do not have a cupboard with allowance for air ow
above the refrigerator, the recommended clearance area on
top increases to 90 mm.
When positioned in a corner area, spacing of at 350mm on
•
the hinge side will allow the doors to open enough to enable
the removal of bins and shelves.
50mm
Recommended
90 mm
airspace
CABINET
DOOR
NOTE: In installation where both sides and the rear of the
refrigerator are not enclosed by cabinetry eg the refrigerator
is placed against a wall, the clerance between the rear of
refrigerator and the wall should not be greater than 75mm.
You refrigerator uses energy efficient components that may
produce different noises (Refer "Noises" page for examples)
to your old refrigerator. Occasionally a gurgling sound of
refrigerator flowing or the sound of parts expanding and
contracting can be hard. These noises are quite normal.
Cleaning Your Refrigerator
Exterior
You should only clean your refrigerator with lukewarm
soapy water and a soft cloth. Rinse with clean water
and then wipe the surface with a soft clean cloth to
remove any soap residue.
Interior
You should clean the refrigerator interior regularly. Wash the
interior with a soft cloth and lukewarm soapy water.
Thoroughly dry all surfaces and removable parts. Avoid
getting water on refrigerator controls. If you have taken out
any removable parts, replace them and switch the power
on before restocking the refrigerator with food. Naturally,
you should keep the interior of your refrigerator hygenic by
promptly and thoroughly wiping up any food spills.
WARNING
Naver use hot water, solvents, commericail, caustic or
abrasive cleaners, or scourers to clean this appliance as
they will damage it. Many commercially available cleaning
products and detergents contain solvents that will damage
your refrigerator. When cleaning, use only a soft cloth and
lukewarm soapy water.
10 mm
7/6/2561 BE 09:25 7/6/2561 BE 09:25