Specifications; Unpacking; Applications - RIDGID R83015 Operator's Manual

SPECIFICATIONS

Chuck ............................................................................................................................................... 1/2 in. (13 mm) Keyless
Motor .................................................................................................................................................................. 14.4 Volt DC
Switch ............................................................................................................................................................ Variable Speed
Gear Train ................................................................................................................................................................. 2 Speed
No Load Speed ......................................................................................................................................... 0-400/0-1600/min.
Clutch .................................................................................................................................................................. 24 Positions
Charger Input ...................................................................................................................................... 120 V, 60 Hz, AC only
Charge Rate .......................................................................................................................................................... 30 minutes
Torque ..................................................................................................................................................... Maximum 415 in.lb.

UNPACKING

INSTRUCTIONS
When unpacking the tool:
■ Carefully remove the tool and accessories from the box.
■ Make sure that all items listed in the packing list are in-
cluded.
■ Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
■ Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
■ If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
PACKING LIST
1/2 in. (13 mm) Two Speed Drill
Charger
Battery Pack (2)
Auxiliary Handle
Double-ended Bit
Operator's Manual
Case

APPLICATIONS

You may use the two speed drill for the purposes listed below:
■ Drilling in wood
■ Drilling in ceramics, plastics, fiberglass, and laminates
■ Drilling in both hard and soft metals
■ Using driving accessories, such as driving screws with screwdriver bits
■ Mixing paints
WARNING:
If any parts are missing do not operate the tool until
the missing parts are replaced. Failure to do so could
result in possible serious personal injury.
7