Brother FAX100 Service Manual page 99

Selector
No.
1
Automatic cutter
CCITT superfine recommendation
2
3 Remote reception
4
Not used.
|
5
6 Exclusive line mode
7
Max. document length limitation
8
Communications list output
Selector 1: Automatic cutter
The selector activates or deactivates the automatic cutter.
Selector 2: CCITT superfine recommendation
If this selector is set to "1", the equipment communicates in CCITT recommended superfine
mode (15.4 lines/mm). If it is set to "0", it communicates in native superfine mode.
Selector 3: Remote reception
Setting this selector to "0" allows the facsimile equipment to receive data from the directly
connected external telephone only. Setting it to "1" allows the equipment to receive data
from all telephones connected in parallel as well as the directly connected external one.
If any of the following troubles occurs frequently, set this selector to "0".
• Dialing from any of the telephones connected in parallel to the outside line starts the fac-
simile equipment.
• Picking up any handset of the telephones connected in parallel while the facsimile equip-
ment is in receiving operation disarranges the received image due to the superimposed
noise.
Selector 6: Exclusive line mode
Setting this selector to "1" connects the equipment to the exclusive line, which enables trans-
mission just by pressing the START button without dialing operation at both the calling and
called terminals.
Selector 7: Max. document length limitation
This selector is used to select the maximum length of a document to be sent.
Selector 8: Communications list output
Setting this selector to "1" prints a communications list for every transmission. This selector
should be set to "1" for error analysis only and set to "0" during ordinary use by the end user.
WSW16
(Function setting 1)
Function
V – 47
Setting and Specifications
0: ON 1: OFF
0: OFF 1: ON
0: Only from the 1: From all
connected
external
telephone
0: OFF 1: ON
0: 400 cm 1: 90 cm
0: No 1: Yes
telephones
connected