Cisco RV016 - Small Business - 10/100 VPN Router Administration Manual page 141

VPN
Setting Up a Remote Access Tunnel for VPN Clients (Client To Gateway)
Cisco Small Business RV0xx Series Routers Administration Guide
DNS hostname (available from providers such as DynDNS.com). Enter a
Domain Name to use for authentication. The domain name can be used
only for one tunnel connection.
- Dynamic IP + E-mail Addr.(USER FQDN) Authentication: Choose this
option if this router has a dynamic IP address and does not have a
Dynamic DNS hostname. Enter any Email Address to use for
authentication.
• Local Security Group Type: Specify the LAN resources that can access
this tunnel.
- IP Address: Choose this option to allow only one LAN device to access
the VPN tunnel. Then enter the IP address of the computer. Only this
device can use this VPN tunnel.
- Subnet: Choose this option (the default option) to allow all devices on a
subnet to access the VPN tunnel. Then enter the subnetwork IP address
and mask.
- IP Range: Choose this option to allow a range of devices to access the
VPN tunnel. Then identify the range of IP addresses by entering the first
address in the Begin IP field and the final address in the End IP field.
• Domain Name: If you chose to use domain name authentication, enter the
domain name.
• Email: If you chose to use email authentication, enter the email address.
Remote Client Setup for Single User ("Tunnel" Type)
Specify the method for identifying the client to establish the VPN tunnel. The
following options are available for a Single User, or "Tunnel" type, VPN.
• IP Only: Choose this option if the remote VPN client has a static WAN IP
address. If you know the IP address of the client, choose IP Address, and
then enter the address. If you do not know the IP address of the client,
select IP by DNS Resolved, and then enter the real domain name of the
client on the Internet. The router will get the IP address of the remote VPN
client by DNS Resolved, and the IP address of the remote VPN client will be
displayed in the VPN Status section of the Summary page.
• IP + Domain Name (FQDN) Authentication: Choose this option if this client
has a static IP address and a registered domain name. Also enter a Domain
Name to use for authentication. The domain name can only be used only for
one tunnel connection.
9
141