Cisco RV016 - Small Business - 10/100 VPN Router Administration Manual page 127

VPN
Viewing the Summary Information for VPN
Cisco Small Business RV0xx Series Routers Administration Guide
Tunnel Status
Above the table, the following information appears:
• Tunnel(s) Enabled: The number of tunnels that are enabled.
• Tunnel(s) Defined: The number of tunnels that are defined, including
enabled and disabled tunnels.
The table displays the following information about each tunnel:
• No.: The identification number of the VPN tunnel.
• Name: A descriptive name for the VPN tunnel.
• Status: The status of the VPN tunnel: Connected or Waiting for Connection.
• Phase2 Enc/Auth/Grp: The Phase 2 Encryption type (NULL/DES/3DES/
AES-128/AES-192/AES-256), Authentication method (NULL/MD5/SHA1),
and DH Group number (1/2/5) that you chose in the IPSec Setup section.
If you selected Manual for the Keying Mode in the IPSec section, then only
the Encryption type and Authentication method appear.
• Local Group: The IP address and subnet mask of the Local Group.
• Remote Group: The IP address and subnet mask of the Remote Group.
• Remote Gateway: The IP address of the Remote Gateway.
• Tunnel Test: Click Connect to verify the status of the VPN tunnel. The test
result will be updated in the Status column. If the tunnel is connected, a
Disconnect button will be available so you can end the connection.
• Configure: Click the Edit icon to open a new page where you can change
the tunnel's settings. To delete tunnel settings, select a tunnel, and then click
the Delete icon
• Tunnel Enabled: The number of enabled VPN tunnels.
• Tunnel Defined: The number of defined VPN tunnels.
• Add: Click this button to add a tunnel. Then choose one of the following
options:
- To create a tunnel for a remote site with a VPN router, choose Gateway
to Gateway. The Gateway to Gateway page appears. See
Gateway to Gateway (Site to Site) VPN, page
9
Setting Up a
130.
127