Advertisement
NETBuilder II Customer-Installable Modules
Dual-Processor Engine Card (DPE) Modules
Trade-Up Kits
Modules
6
NETBuilder II DPE 40
n Multiprocessor architecture to
offload complex WAN services
n 40 MB memory
n Midrange—high-performance
throughput
n Key requirements—cost sensitivity
CEC to DPE 40 Module Trade-Up Kit
n Includes DPE 40 module and NETBuilder II
Extended WAN software on 20 MB flash card
HSS 8-Port BRI Modules
n Choice of S/T or U version
n Eight RJ-45 connectors per module
n Bandwidth flexibility; one B channel
(64 Kbps) to 32 B channels (2.048 Mbps)
n Multiple channels may be bonded together
using Multilink protocol.
NETBuilder II HSSI Module
n Single 50-pin HSSI (High-Speed Serial Interface)
connector
n Support for ATM with ATM DXI and WAN services
including PPP, Frame Relay, and SMDS
n Support for STS-1 and SONET OC-1 (52 Mbps),
T3 (45 Mbps), E3 (34 Mbps), and subrates
Fast Ethernet Modules
(100BASE-TX and 100BASE-FX)
n One port either 100BASE-TX (RJ-45) or
100BASE-FX (SC)
n On-board hardware filtering
Token Ring+ Module
n RJ-45 and DB-9 AUI connectors
(auto sensing)
n Software-selectable 4/16 Mbps and
on-board hardware filtering
MP ATMLink Module
n Choice of multimode and single-mode
models
n One OC-3c/SDH fiber interface with
SC connectors
n Support for ATM with ATM UNI
n Multiprotocol encapsulation over ATM
n LANE
MP Ethernet 6-Port Modules
n Six RJ-45 10BASE-T or six ST 10BASE-FL
connections
n MP architecture for high-speed, on-board
filtering and forwarding
n On-board RISC processor
NETBuilder II DPE plus
n Multiprocessor architecture to
offload complex WAN services
n 80 MB memory
n High-performance throughput
n Key requirements—high-performance
forwarding and compression throughput
CEC to DPE plus Module Trade-Up Kit
n Includes DPE plus module and NETBuilder II
Extended WAN software on 20 MB flash card
HSS 4-Port WAN Module
n Standard format module; includes a
hydra cable that fans out to four cables,
each with a FlexWAN connector
n Supports RS-232, V.35, X.21, RS-449,
and EIA530 signalling in DTE or DCE
mode through the use of auto-sensing
FlexWAN cables
n Support of four ports at T1/E1 rates
concurrently, or two ports at 4 Mbps
concurrently
HSS G.703 Module
n Single CCITT G.703 WAN interface
n Twin 77 ohm coax connector
n Standard G.703 2.048 Mbps E1
line speeds
Ethernet 2-Port 10BASE-FL Module
n 10BASE-FL fiber connections through
ST connectors
n Compatible with FOIRL hubs
Ethernet Module
n Single-port AUI or BNC connectors
(autosensing)
n Full media-speed performance
FDDILink Modules
n Single-MAC single-attached station
(SAS) or dual-attached station (DAS)
n Media-speed filtering rates
n Choice of multimode/multimode,
single-mode/single-mode, single-
mode/multimode, and multimode/
single-mode models
Advertisement
