Interior Cleaning; Condenser Cleaning - Electrolux 5995421657 Use & Care Manual

22
Maintenance
Interior Cleaning - As Required
1 Disconnect power to the wine cooler.
2 Remove racks if desired, see WINE RACK REMOVAL/INSTALLATION.
3 Wipe down the interior with a solution of non-abrasive mild detergent and
warm water.
4 Rinse with clear water.
5 Reconnect power to the unit.
Condenser Cleaning - Every 3 Months
WARNING WARNING
WARNING WARNING WARNING
!
Disconnect electric power to the unit before cleaning the condenser.
Figure 25
CAUTION CA CA
CA CA
!
DO NOT touch the condenser fins. The condenser fins are SHARP. The fins can also be
easily damaged.
4 Clean the condenser coil using a brush or vacuum cleaner. Do not touch.
5 Position the grille to align the screw holes with the cabinet.
6 Insert the grille screws and tighten being careful not to over tighten.
7 Install the control knob by aligning the flat of the control knob with the flat on
the shaft. Push firmly.
UTION UTION UTION
UTION
To remove and replace the grille for access to
the condenser fins follow this procedure:
1. Remove the control knob by grasping the
knob and pulling straight off (see
Figure 25).
2. Remove the screws at each end of the
grille.
3. Remove the grille.