Miele W 2662 WPS Operating Instructions Manual page 40

<25%
Zero setting not possible
Empty drum
40
There was already
laundry in the drum
when the washing
machine was
switched on. This
has decalibrated
the sensor from the
zero setting.
The load size
sensor has been
decalibrated from
the zero position.
The drum door is
closed.
^ To recalibrate the sensor to the
zero setting:
– Remove the laundry from the
drum.
– Switch off the washing
machine and leave the door
open.
– Switch on the washing
machine.
– Turn the programme selector
to the Cottons 95°C position.
– Press and hold the Load/
Detergent button until the
following appears in the
display:
Zero setting OK
Rotate the drum once. If the
display still indicates a load
<25%
greater than
the sensor to zero again (see
above section).
– Open the drum door.
– Switch off the washing
machine and leave the door
open.
– Switch on the washing
machine.
– Try and recalibrate to zero
again.
.
, recalibrate