Pre-Wash; Soak - Miele W 2662 WPS Operating Instructions Manual

E
The load size indicator display will be
replaced with the detergent percentage
display.
Detergent 75%
A
40%
Add slightly less than half the
amount recommended . . .
50%
Add half the amount
recommended . . .
60%
Add slightly more than half the
amount recommended . . .
75%
Add three quarters of the
amount recommended . . .
100%
Add the full amount
You also need to take the level of
soiling and water hardness into
account.
too little detergent results in:
– Laundry not getting properly clean
and with time it may become grey
and hard to the touch.
– Greasy particles clinging to the
laundry.
– Limescale deposits on the heater
elements.
too much detergent results in:
– Excessive foam which causes a low
level of agitation and poor wash,
rinse and spin results.
– High water consumption (an
additional rinse cycle will
automatically switch in).
– A burden to the environment.
^ Pull out the detergent drawer and
add detergent to the compartments
as follows:
i
Detergent for the pre-wash (
total amount recommended).
This compartment is also used for
starch formulations when starching
separately.
j
Detergent for the main wash
including Soak
§
Fabric conditioner or liquid starch
^ Close the detergent drawer.
See "Detergent" for further information.
1
/ of the
4
17