Black Widow Security BW X-Z Series System Manual page 14

• GREEN/YELLOW WIRE - Parking Light
output (+) 7.5A relay. Used for vehicle's with
independent left and right parking light circuits;
see GREEN/BLACK wire.
• YELLOW WIRE - +12V Ignition input.
Connect to a main ignition wire at the ignition
switch harness.This wire shows +12V when the
ignition is on and while cranking. The voltage
must not drop when the car is starting.
• GRAY WIRE - Siren output (+) 2A. Connect
to the siren's red wire. Connect the siren's
black wire to ground. If the siren is not
installed, the GRAY wire may be connected to
a relay to pulse the vehicle's horn. Alarm
Programmable Feature step 8 must be set to
Horn mode. See Alarm Programmable Features
• YELLOW/BLACK WIRE - Auxiliary / trunk
release output (-) 500mA. Connect to a relay
for optional features such as trunk release, etc.
• BLUE/BLACK WIRE - Negative door trigger
(-). Connect to the door switch circuit wire
that shows ground when the door is open.
• ORANGE/GRAY WIRE - Hood trigger (-).
Connect to an optional hood pin switch that
shows ground when the hood is open.
Starter Defeat/Anti-Grind Relay Socket
See Starter Defeat Relay Wiring Diagrams for
expanded wiring and programming information.
• BLACK/RED and YELLOW WIRES -
Combined in 2-pin harness. Plug into 2-pin
connector from 14-pin main harness.
• BLUE WIRE - Starter defeat output to starter
wire. After cutting the vehicle's starter wire,
connect the BLUE wire to the side running to
the starter.
• BLUE/WHITE WIRE - Normally closed
starter defeat input. After cutting the vehicle's
starter wire, connect the BLUE/WHITE wire to
the key side of the ignition wire if normally
closed operation is desired (default).
• BLUE/RED WIRE - Normally open starter
defeat input. After cutting the vehicle's starter
wire, connect the BLUE/RED wire to the key
side of the ignition wire if normally open
operation is desired. Alarm Programmable
Feature step 10 must be set to button 2. See
Alarm Programmable Features
Alarm Module Connectors
4-Pin Connector: Plug-in connector for
optional dual-zone sensor. See Alarm Module
Wiring Diagram for pin descriptions.
2-Pin Connector:
valet/override switch. Mount switch in an area
easily accessible from the driver's position.
2-Pin Connector: Plug-in connector for LED.
Mount LED in an area where it may be easily
seen from either side of the vehicle.
4-Pin Connector: Plug-in connector for
extended range receiver.
3-Pin Blue Connector: Not used.
3-Pin Black Connector: This connector links
the alarm module to the optional remote start
module using a 3-wire data-link harness.
2-Pin White Connector: Plug-in connector for
shock sensor.
OPTIONAL START MODULE WIRING
6-Pin Main Starter Harness
• BLUE WIRE - Main accessory output (+).
12V output for heater and/or air conditioning
system. For cars with more than one accessory
wire add a relay(s) to power the extra
accessory wire(s) or set dip switch #3 to ON
and use the GREEN wire for second accessory.
• YELLOW WIRE - Main ignition output (+).
Connect to the main ignition wire that switches
+12 V and does not drop out during cranking.
• GREEN WIRE - Second ignition output (+).
Connect to the vehicle's second ignition wire (if
equipped). This wire may be optionally set for
use as a second accessory wire or second
starter wire. See Dip Switch Settings
14
Plug-in connector for