Black Widow Security BW RAS 400 Installation Manual page 6

SECURITY/REMOTE START WIRING DIAGRAM
GREEN
RED
BLUE
1 2 3 4
DIP SWITCH SETTINGS
Default settings from
factory are= ON
1. OFF= Reads GREEN tach/spark sense wire.
2. OFF= Reads YELLOW wire (3-pin accessory plug)
for optional vacuum kit
3. OFF= Extend cranking time; will auto adjust.
4. OFF= Diesel – ignition will turn ON several
seconds before starting vehicle.
FIGURE 1. OPTIONAL VACUUM
SYSTEM HOOK-UP
VACUUM
GROUND
SWITCH
EXISTING CAR
VACUUM HOSE
For vacuum switch hook-up dip switch #2=OFF
DOOR LOCK OUTPUT (-)
+12V CONSTANT OUTPUT
DOOR UNLOCK OUTPUT (-)
GREEN/BLACK
RED
YELLOW
#1
#2
#3
#4
CONNECTORS
#5
#6
Automatically starts engine every 2 hrs. for 24 hrs. max.
Hold both program switch and button #2 for 5 seconds,
parking lights will flash 5 times and remain on. Engine will
YELLOW
EXISTING CAR
VACUUM HOSE
Hold both program switch and button #2 for 5 seconds,
parking lights will flash 10 times to confirm deactivation.
You may also deactivate the Cold Start feature by stepping
on the brake pedal at any time or turning ON the ignition.
6
TRUNK OUTPUT (-)
FACTORY DISARM OUTPUT (-)
VACUUM SWITCH INPUT
SWITCH
WHITE
PARKING LIGHT OUTPUT (+)
RED
+12V INPUT
BROWN
NOT USED
BLACK
GROUND INPUT
ORANGE
ALARM AUXILIARY INPUT (-)
GRAY
REMOTE START OUTPUT (-)
GREEN
SPARK OR TACH SENSE (-)
BLUE
HOOD SWITCH INPUT(-)
VIOLET
NOT USED
YELLOW
(+) BRAKE SWITCH INPUT
VIOLET
STARTER OUTPUT
ORANGE
ACCESSORY OUTPUT
YELLOW
IGNITION #1 OUTPUT
BROWN
IGNITION #2 OUTPUT
RED
CONNECT DIRECTLY
RED
TO THE BATTERY
COLD START ACTIVATION
(Keyless Entry/Remote Start module only
start and run for 30 seconds to confirm activation.
Once activated the engine will start up automatically
and run for a preset period of time.
COLD START DEACTIVATION
(Keyless Entry/Remote Start module only
OR...remote start the vehicle.
)
)