Remote Programmable Features - Black Widow Security BW FM 200 Installation Manual

Fm security and remote start system
Hide thumbs Also See for BW FM 200:
Table of Contents

Advertisement

3-Pin Red Connector: Plug-in connector port
for optional features harness.
• GREEN/BLACK WIRE - 3rd channel output (-).
Connect to a relay for optional trunk release etc.
• RED WIRE - Factory Disarm output (-).
Connect to the wire that requires a ground
pulse to disarm the factory alarm system. The
RED wire provides a ground pulse when the
remote transmitter is used to unlock the doors
or start the vehicle.
• YELLOW WIRE - Vacuum Switch input. For
diesel vehicles, or vehicles where a tach wire or
spark plug wire is not available, the YELLOW
wire may be connected to an optional vacuum
switch. Connect the other side of the vacuum
switch to ground.

Remote Programmable Features:

Step
Function
1.
Arming Mode
2.
Passive Lock
3.
Auto Re-arm
4.
Normal/Silent Arming
5.
Door Unlock Pulse
6.
Door Lock Pulse Length
7.
Ignition Lock
8.
Auto Cold Start Defeat
9.
Cold Start Timing
10.
Trunk Disarm Feature
11.
Passive Arm Warning Chirps Delete
12.
Open Zone Chirp Timing
13.
Remote Start Run Time
14.
Lock Before & After Engine Crank
15.
Lock After Engine Shutdown
16.
Parking Light Operation
2-Pin Red Connector: Plug-in connector port
for LED. Mount LED in an area where it may be
easily seen from either side of the vehicle.
2-Pin Blue Connector: Plug-in connector port
for program/service switch. Mount program
switch in an area that is easily accessible from the
driver's position.
2-Pin White Connector: Plug-in connector port
for horn honk/dome light harness.
• WHITE/YELLOW - horn output (-)
• RED/BLACK - Dome light output (-)
5-Pin Antenna Connector: Plug-in connector
port for extended range receiver. Plug harness
into 5-pin connector, route cable up pillar post,
place double sided tape on flat side of receiver
module and place in corner of windshield.
Button 1 (On)
Passive
On
On
Normal
Single
.75 Seconds
On
Disable Cold Start
Every 2 Hours
Disable
On
10 Seconds
15 Minutes
On
On
Normal
4
Button 2 (Off)
Active
Off
Off
Silent
Double
3 Seconds
Off
Enable Cold Start
Every 1 Hour
Enable
Off
60 Seconds
25 Minutes
Off
Off
Car Locator Feature

Advertisement

Table of Contents
loading

This manual is also suitable for:

200

Table of Contents