Black Widow Security OEM UPGRADE SERIES User Manual page 8

factory keyless entry transmitter.
4. If the multimeter does not show any
change in polarity when locking or
unlocking the doors using the factory
transmitter, skip ahead to directions for
No Switch Feedback Type or Universal
Basic. If the multimeter shows a positive
or negative pulse when using the factory
transmitter, continue on to Step 5.
5. For vehicles that show a positive or
negative pulse when using the factory
transmitters, it is necessary to determine
the keyless entry system type. If all doors
unlock each time the transmitter button
is pressed, follow the directions for
Standard Type. If the vehicle is equipped
No Switch Feedback Type
This system type shows no feedback on the door lock wires from the keyless entry
module when the transmitter buttons are pressed. The door lock relays are usually
LOCK/UNLOCK
SWITCH
L
UL
YELLOW
FACTORY KEYLESS
ENTRY MODULE
WITH BUILT-IN
LOCK RELAYS
BLUE
GREEN
with a two-stage unlock feature that
unlocks only the driver door upon first
press of the unlock button and then
unlocks all doors when pressed again, cut
the unlock wire and continue to Step 6.
6. If the driver door continues to unlock
after the wire is cut but the passenger
doors do not unlock, follow the
directions for Built-in Driver Unlock Relay
Only. If the doors no longer unlock,
follow the direction for Two-Step Type or
Universal Two-Step Type.
buit-into the keyless entry
module in this system type.
When connected as shown
below the system will arm
or disarm only with the
keyless entry transmitter,
and the door switches will
have no affect on the secu-
rity system.
DOOR LOCK
MOTOR
8