Nautilus Commercial TreadClimber TC916 Service Manual page 23

e:
to reSet the treaDle center
In SoftWare to match the
treaDle center on the
encoDer, folloW theSe StepS:
9e-1: From the Intro screen, press [Speed UP] [6]
[ENTER]. The display will read "DIAGNOSTIC".
Press the [Speed UP] or [Speed DOWN] keys
to scroll through the options until "TREADLE
CENTER" is displayed. Press [ENTER].
9e-2: The top line of the display will read: "VIRTUAL
CENTER - XX" (see Figure E-1). With the treadles
held parallel, press the [STOP] key. The number
on the display will be used by the software for the
center point position. When STOP key is pressed
the number will change to a value between 0
to 255. This means the treadle center in the
software has been recalibrated to match the
center position of the encoder.
9e-3: Press [CLEAR] twice to exit the Diagnostic mode.
Move the treadles up and down until the treadles
lock. Verify that the treadles lock parallel to each
other or within 1" of parallel.
9e-4: If the treadles do not lock parallel or close to
parallel, then 1) recheck the center position on the
encoder PCB (section B); 2) recheck the encoder
range (section D); 3) recheck the treadle center in
software (section E).
figure e-1
Nautilus® TreadClimber®, Model TC916 Service Manual
mechanIcal ServIce