Table of Contents
Advertisement
The appliance plinth below the door
can be fitted with a plinth facing to
match your kitchen.
The height and return of the appliance
plinth cannot be altered.
A taller plinth facing can only be fitted if
the overall niche height is higher.
100 mm
820 mm
(standard)
150 mm
870 mm
200 mm
920 mm
A plinth facing (600 mm long) can be
ordered from your Kitchen Dealer or
manufacturer.
Before fitting the plinth facing,
please note: Under no
circumstances must anything be
stuck over the flap(s) in the
appliance plinth.
Stick the velcro fastener provided to the
appliance plinth.
For this the following procedure is
recommended:
^ Match up the hooked side and the
^ Cut it into 2 or 3 sections.
^ Peel the protective backing off one
one spacer
^ Position the velcro strips along the
frame is
required
two spacer
frames are
required
^ Carefully remove the remaining
^ Press the plinth facing onto the
looped side of the velcro strip
lengthwise.
side of the lengths of velcro.
appliance plinth, at the left and right
hand sides and in the middle and
then press firmly into place.
protective foil from the velcro.
adhesive surface of the velcro strips
and press firmly into position.
57
Hide quick links:
Advertisement
Table of Contents
