Fitting A Plinth Facing - Miele W 939 WPS Operating Instructions Manual

The appliance plinth below the door
can be fitted with a plinth facing to
match your kitchen.
The height and return of the appliance
plinth cannot be altered.
Higher plinth can only be fitted if the
overall niche height is higher.
100 mm 820 mm
(standard)
150 mm 870 mm
200 mm 920 mm
A plinth facing (600 mm long) can be
ordered from your Kitchen Dealer or
manufacturer. For Miele kitchens please
quote the model number of your ma-
chine when ordering.
Before fitting the plinth facing, please
note: Under no circumstances must
anything be stuck over the flap(s) in
the appliance plinth.
56
^ Stick the velcro strip provided to the
For this the following procedure is rec-
ommended:
^ Match up the hooked side and the
^ Cut it into 2 or 3 sections.
^ Peel the protective backing off one
one raising kit is
required
^ Position the velcro strips along the
two raising kits
are required
^ Carefully remove the remaining pro-
Press the plinth facing onto the adhe-
sive surface of the velcro strips and
press firmly into position.
appliance plinth.
looped side of the velcro strip length-
wise.
side of the lengths of velcro.
appliance plinth, at the left and right
hand sides and in the middle and
then press firmly into place.
tective foil from the velcro.