Table of Contents
Advertisement
Installation
Fitting a plinth facing
The appliance plinth below the door
can be partially concealed using a
plinth facing.
The height and return of the appliance
plinth cannot be altered.
A taller plinth facing can only be in-
stalled if the overall niche height is
higher.
Plinth
Niche height
height
100 mm (stan-
dard)
150 mm
200 mm
A plinth facing (600 mm long) can be
ordered from your kitchen Dealer or
manufacturer. For Miele kitchens please
quote the model number when order-
ing.
Before fitting the plinth facing, please
note:
Under no circumstances must any-
thing be stuck over the flap(s) in the
appliance plinth.
In order to open the drum door dur-
ing an emergency the plinth facing
must be removable.
60
820 mm
870 mm
one spacer
frame is re-
quired
920 mm
two spacer
frames are re-
quired
Fitting the plinth facing:
Stick the velcro fastener provided to the
appliance plinth.
For this the following procedure is rec-
ommended:
^ Match up the hooked side and the
looped side of the velcro fastener
lengthwise.
^ Cut into 2 or 3 pieces.
^ Peel off the protective backing from
one of the velcro fastener pieces.
^ Position the cut pieces along the ap-
pliance plinth, at the left and right
hand edge, and in the middle, avoid-
ing the drain flaps. Press firmly into
place.
^ Now peel the protective backing off
the other velcro fastener piece.
^ Address the plinth facing to the ad-
hesive backing and press firmly into
place.
Washer and dryer Stack
A Miele tumble dryer can be stacked
with this washing machine. A stacking
kit* and special accessories* are nec-
essary.
* All parts marked * are available from
the Miele Spare Parts or Sales depart-
ments and from some Miele Dealers.
Hide quick links:
Advertisement
Table of Contents
