Enabling The Syslog Server - NETGEAR WN604 - Wireless-N 150 Access Point Reference Manual

Enabling the SysLog Server

The SysLog screen allows you to enable the SysLog option if you have a SysLog server on your
LAN.
To enable a SysLog server:
1. Under the Configuration tab on the main menu, select System, then select the Advanced
option, and select SysLog to view the screen shown in
Figure 4-6 Enable Syslog server
2. Enable SysLog – Enable this option if you have a SysLog server on your LAN. If enabled,
you must enter the IP address of your SysLog server and the port number your SysLog server
is configured to use. The default is Disabled.
3. SysLog Server IP Address –The access point will send all the SysLog to the specified IP
address if SysLog option is enabled.
4. Port Number – The port number configured in the SysLog server on your LAN. Default is
514.
5. Click Apply to save your Syslog settings.
Management
NETGEAR Wireless N150 Access Point WN604 Reference Manual
v1.0, March 2010
Figure 4-6.
4-7