Panasonic HDCSDT750 - HD 3D CAMCORDER Workshop Manual page 44

[QUICK POWER ON]
The unit is put into recording pause approx. 1 second when the unit is turned on with the
mode set to or
≥ Depending on the recording conditions, start time may be longer than 1 second.
≥ In the Quick power on mode, the zoom magnification becomes 1k.
[QUICK START]
This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened
or the viewfinder is extended.
≥ When in Quick start standby mode about 80% of the power used in Recording pause
mode is being consumed, so the recording time will be reduced.
≥ Quick start will not work if there is no SD card inserted.
≥ Change the mode to
1 Set [
QUICK START
2 Close the LCD monitor and retract the
viewfinder while the mode is set to
or .
The status indicator A flashes green and the unit
goes into Quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor or extend
the viewfinder.
The status indicator A lights red and the unit
is put into recording pause.
≥ Quick Start Standby Mode is canceled if
j about 5 minutes have elapsed
j mode is set to
≥ Time for Quick start will be more than 0.6 seconds slower when the Digital cinema is used.
≥ Depending on the recording conditions, time for Quick Start may be more than 0.6 seconds
slower in Still Picture Recording Mode.
≥ It may take some time for Automatic white balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes 1k.
≥ If [ECONOMY] (l 43) is set to [5 MINUTES] and the unit automatically goes into Quick
Start Standby Mode, close the LCD monitor and viewfinder and then open the LCD monitor
or extend the viewfinder again.
≥ Turn the unit off using the power button.
≥ Quick start standby mode cannot be released by the remote control.
44
VQT3B18
[OFF]/[ON]
.
[OFF]/[ON]
or .
] to [ ].
ON