Panasonic HDCSDT750 - HD 3D CAMCORDER Workshop Manual page 144

Problem
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
Item other than the
touched one is
selected.
The remote control
does not function.
The remaining time
indication or the
elapsed time
indication is not
shown.
The unit arbitrarily
stops recording.
Auto focus function
does not work.
144
VQT3B18
≥ Remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery or AC
adaptor. Then about 1 minute later, turn on the unit
again. (Conducting the above operation while the
media is being accessed may damage the data on
the media.)
≥ If normal operation is still not restored, detach the
power connected, and contact consumer support.
(l 170, 171, 172)
≥ Calibrate the touch screen. (l 47)
≥ [REMOTE CONTROL] of the [SETUP] is [OFF].
(l 49)
≥ The button-type battery of the remote control may
have run out. Replace it with a new button-type
battery. (l 49)
≥ [DISPLAY] of the [SETUP] is [OFF]. (l 42)
≥ Use an SD card that can be used for motion picture
recording. (l 23)
≥ The recordable time may have shortened due to the
deterioration of the data writing speed or repeated
recording and deletion. Using the unit, format the SD
card. (l 47)
≥ If [AGS] is [ON], record in the normal horizontal
position or set [AGS] to [OFF]. (l 75)
≥ Switch to Intelligent Auto Mode.
≥ If you are trying to record a scene which is hard to
bring into focus in Auto Focus Mode, use the Manual
Focus Mode to adjust the focus. (l 36, 89)
Check points