Panasonic AG-MSU10 Operating Instructions Manual page 46

 Error message list
Message
CANNOT An error occurred during P2 card access.
ACCESS
CARD!
CANNOT An error occurred during storage device
ACCESS access.
TARGET!
CANNOT Last copy or format operation failed be-
ACCESS! cause an error occurred on the P2 card or
storage device.
CANNOT COPY! An error occurred on the P2 card or stor-
age device during copying.
CANNOT COPY! Copying cannot be completed because
FORMAT the partition selected as the copy target
STORAGE does not exist.
DEVICE TO FAT
CANNOT The P2 card or storage device cannot be
FORMAT! formatted.
CANNOT The storage device cannot be properly
RECOGNIZE recognized.
STORAGE
DEVICE!
CARD ACCESS An error occurred during P2 card access.
ERROR!
CARD IS EMPTY! The P2 card being used as the copy
CANNOT COPY! source is empty.
DEVICE Last copy or format operation failed be-
DISCONNECTED! cause the P2 card or storage device was
disconnected.
LACK OF There is not enough free space on a P2
CAPACITY! card or storage device used as the copy
target.
LAST COPY Last copy operation failed.
FAILED.
LAST COPY Last copy operation was successful.
SUCCESSFUL.
LAST FORMAT Last format operation failed.
FAILED.
LAST FORMAT Last format operation was successful.
SUCCESSFUL.
LOW BATTERY! The battery is running low.
NOT SELECTED! No clip is selected.
POWER LOST! Last copy or format operation failed be-
cause the power supply was interrupted.

Description Measure
Check P2 card.
Check storage device status and connec-
tions.
Check the P2 card or storage device and
try again.
Check the P2 card or storage device.
Format the storage device using FAT or
use a device with a formatted partition.
Check the P2 card or storage device.
Reboot the storage device or connect a
different device.
Check P2 card.
Copying cannot take place as there is no
data on the copy source.
Connect the device properly and try
again.
Use a P2 card or storage device with suf-
ficient free space.
Copy the data again.
–
Format the device again.
–
Replace the battery or connect the AC
adapter.
Select clips before copying.
Replace the battery or connect the AC
adapter and try again.