Preparation; Charging The Battery - Panasonic AG-MSU10 Operating Instructions Manual

The battery is not charged when the product is
purchased. Use the steps below to fully charge the
battery using the supplied charger.
1
Place the battery level on the charger
and slide it in the direction of the arrows
on the charger.
2
Connect the AC power supply cable to
the charger and connect the power plug
to a wall outlet.
• The POWER lamp and CHARGE lamp on
the charger lights indicating that charging
has started.
• If the CHARGE lamp does not light when
the battery is installed, reinstall the battery
correctly.
• The CHARGE lamp on the charger goes
out when charging ends.
3
Slide the battery off the charger.

Preparation

Charging the battery

 Charging time and battery life estimates for the
supplied battery
Capacity
Charging time
Continuous copying time Approx. 400 min.
• The table above shows expected battery per-
formance with an E-series P2 card in the AG-
MBX10G removable interface box.
• This level of performance is achieved at an ambi-
ent operating temperature of 20 °C (68 °F) and
an ambient operating humidity of 60 %. Higher
temperature and humidity levels will extend the
charging time.
• The battery becomes hot during charging.
• When the battery temperature becomes exces-
sively high or low, or it has become discharged
after a long period of inactivity, the CHARGE lamp
may flash a two or three times before automatic
charging starts.
• If the CHARGE lamp continues flashing when the
battery is at normal temperature, it may be defec-
tive and you should contact your supplier.
• Charging time becomes longer for a hot battery.
• Using the charger or AC adapter near a radio may
interfere with radio reception. Place the charger or
AC adapter at least 1 meter away from a radio.
• The charger may emit noise during charging. This
is not a malfunction.
• No guarantees are given for the operation of the
CGR-D16/CGR-D16s (1600 mAh) battery pack.
5400 mAh
Approx. 330 min.
1