Honda 2011 CR-V Owner's Manual page 366

Lights
BULB
WEATHER SEAL
Remove the electrical connector
2.
from the bulb by pulling the
connector straight back.
3. Remove the rubber weather seal
by pulling on the tab.
4. Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way, and remove the bulb.
360
5. Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
Install the rubber seal over the
6.
back of the headlight assembly.
Make sure one of the three arrows
on the rubber seal is facing up; it is
marked '' .''
CONNECTOR
7. Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.
8. (Driver's side)
Reinstall the under-hood fuse box.
Replacing a Front Turn Signal
Light Bulb
HOLDER
1. Open the hood.
To change the turn signal bulb on
the driver's side, remove the
engine coolant reserve tank by
pulling it out of its holder.