Removing A Memory Upgrade Module; Checking The Memory Capacity - Fujitsu LifeBook S761 User Manual

T
HE MEMORY UPGRADE MODULE IS NOT SOMETHING YOU ROUTINELY REMOVE FROM YOUR NOTEBOOK
O
NCE IT IS INSTALLED
MEMORY CAPACITY

Removing a Memory Upgrade Module

1
Perform steps 1 through 4 of Installing a Memory Upgrade Module.
2
Pull the clips sideways away from each side of the memory upgrade module at the same time.
3
While holding the clips out, remove the module from the slot by lifting it and pulling it away from your notebook.
4
Store the memory upgrade module in a static guarded sleeve.
5
Replace the cover and reinstall the screws.

Checking the Memory Capacity

Once you have changed the system memory capacity by replacing the installed module with a larger one,
be sure to check that your notebook has recognized the change.
Check the memory capacity by clicking [Start] -> Settings -> Control Panel, then (while in Category view)
clicking the System and Security icon. Select the Security icon and check the amount of memory next to
"Installed memory (RAM):".
There may be a variation between the actual memory size and what is displayed. This is possible if your
system is configured with a graphics controller which dynamically allocates system memory to accelerate
graphics performance.
I
F THE TOTAL MEMORY DISPLAYED IS INCORRECT
PROPERLY INSTALLED
CORRECTLY RECOGNIZED
,
YOU SHOULD LEAVE IT IN PLACE UNLESS YOU WANT TO CHANGE SYSTEM
.
. (I
F THE MODULE IS PROPERLY INSTALLED AND THE CAPACITY IS STILL NOT
, T
SEE ROUBLESHOOTING ON PAGE
80 - yMemory Upgrade Module
,
CHECK THAT YOUR MEMORY UPGRADE MODULE IS
89.
.