Checking Jumper Settings; Jumper Settings - ECS IC41T-A User Manual

Checking Jumper Settings

The following illustration shows the location of the motherboard jumpers. Pin 1 is
labeled.

Jumper Settings

Jumper Type Description
CLR_CMOS 3-pin CLEAR CMOS
Rear USB/PS2
3-pin
USBPWR_R
Power Select
Jumper
Front Panel
USBPWR_F 3-pin
USB Power
Select Jumper
To avoid the system instability after clearing CMOS, we recommend
1.
users to enter the main BIOS setting page to "Load Default Settings"
and then "Save & Exit Setup".
2. Make sure the power supply provides enough 5VSB voltage before se-
lecting the 5VSB function.
3. It is required that users place the USBPWR_F & USBPWR_R cap onto
2-3 pin rather than 1-2 pin as default if you want to wake up the
computer by USB/PS2 KB/Mouse.
Installing the Motherboard
Setting (default)
1-2: NORMAL
1
2-3: CLEAR
Before clearing the
CLR_CMOS
CMOS, make sure to
turn the system off.
1
1-2: VCC
2-3: 5VSB
USBPWR_R
1
1-2: VCC
2-3: 5VSB
USBPWR_F
9