Installing Machine On Carriage - Baby Lock Jewel BL J18 Instruction And Reference Manual

Installing Machine
on Carriage
1.
Place the carriage on the table rails ensuring that the carriage
stitch regulator assembly is toward the front of the table (Photo 1).
2.
The stitch regulator, machine and carriage are connected by a
ribbon cable that has 3 connectors (Photo 2). The machine should
arrive from the factory with the ribbon cable already attached
by Connectors A and B. The remaining end, Connector C, will be
connected in Step 4.
NOTE: Connector A is a serial port connector and connects
at position 31 as seen in (Rear Diagram C, #31 on page 6).
Connector B connects to the machine stitch regulator assembly
shown in (Back-Side Diagram B, #14 on page 6), as well
as (Photo 3). If these two connections have come loose in
shipping, reconnect them before proceeding to step 3.
3.
Place the machine on the carriage, with the front of the machine
toward the front of the table and all wheels on the carriage rails.
4.
Plug final ribbon cable Connector C into the carriage stitch
regulator assembly (Photo 1).
C
Photo 2
B
A
Front of
table
Carriage
Stitch
Regulator
Assembly
Back of
table
Photo 1
Photo 3
7