Installing The Laser Stylus - Baby Lock Jewel BL J18 Instruction And Reference Manual

Installing the
Laser Stylus
CAUTION LASER SAFETY:
When using the Laser Stylus, basic safety
precautions should be taken.
• Never shine directly into the eyes.
• The Laser Stylus should never be left on
and unattended.
• Laser Stylus is not to be used as a toy.
• Close attention is necessary when
the laser stylus is being used by or near
children.
• Use Laser Stylus only for its intended use
as described in this manual.
Begin by locating the laser stylus guide post, the
laser clamp and the laser stylus (Diagram E).
Laser Stylus
Guide Post
Diagram E
To attach the laser stylus
to the top of the machine:
1.
Locate the threaded hole on top of the ma-
chine near the front (Back-Side Diagram B, #20,
page 6). The laser stylus guide post comes with the
washer and nut on it. Remove the nut and washer,
replace the nut onto the post and then place the
washer under the nut and onto the machine
painted surface. The washer protects the painted
surface when the nut is tightened. Tighten the post
clockwise until it is securely in place. Use the nut
to secure the post to the machine.
2.
Be sure the laser stylus is inserted into the laser
clamp.
3.
Slide the laser clamp over the post to the
desired height and secure by tightening the black
thumbscrew.
4.
Plug the laser into the top port on the side of
the front electronic control cover (Rear Diagram
C, #29, page 6).
To attach the laser stylus
to the side of the machine:
1.
Place the nut on the laser stylus guide post
with the washer under it and thread the laser
Laser
guide post into the threaded hole on the front of
Clamp
the machine (Front-Side Diagram A, #13, page 5
Laser
and Photo 12). Turn until securely in place. Lock
Stylus
in place with lock nut—the washer will be under
the nut to protect the machine paint. (An unused
spool pin can also be used to mount the laser
instead of the Laser Stylus Guide Post, Photo 12).
Photo 12
13