Engine Oil - Honda EG4000CL Owner's Manual

3. After all the gasoline has drained into the container, tighten the
drain bolt securely.
4. Place a suitable gasoline container below the sediment cup, and use
a funnel to avoid spilling gasoline.
5. Remove the sediment cup (see page
valve lever to the ON position.
6. Allow the gasoline to drain completely, and then install the sediment
cup (see page
FUEL VALVE LEVER

Engine Oil

1. Change the engine oil (see page 39).
2. Remove the spark plug, and pour between one and two teaspoons
(5 cc) of clean engine oil into the cylinder. Crank the engine several
revolutions to distribute the oil, then reinstall the spark plug.
3. Slowly pull the starter grip until resistance is felt. At this point, the
piston is coming up on its compression stroke, and both the intake
and exhaust valves are closed. Storing the engine in this position
will help to protect it from internal corrosion.
47 ).
47 ), and then turn the fuel
O O N N
Align the notch on the starter pulley
with the hole at the top of recoil starter.
STORAGE
51