Baby Lock ellure plus BLR2 Instruction And Reference Manual page 186

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
APPENDIX
Error Message Probable Cause
You tried to combine more than 70 decorative stitches, satin stitches,
cross stitches or combined utility stitches.
The memory is full and the stitch or pattern cannot be saved.
You pressed the back key or the utility stitch key or the embroidery key
while a pattern was selected.
You changed the stitch pattern settings, and then tried to save them by
pressing the manual memory key.
You tried to select an embroidery pattern or change the layout when
the needle was down.
The machine is turned on while the needle is lowered and the
embroidery unit is attached.
This message is displayed when the embroidery unit is trying to
initialize while the embroidery foot is lowered.
When 13 or more patterns are in "Removable Disk", a pattern was
being retrieved.
Retrieving the pattern
The "Reverse/Reinforcement Stitch" button, "Needle Position" button
or "Thread Cutter" button was pressed while the bobbin winder shaft is
moved to the right.
A pattern is being saved.
The "Start/Stop" button or "Reverse/Reinforcement Stitch" button was
pressed when no pattern is selected.
Bobbin thread has run out.
Little bobbin thread remains.
When the embroidery unit is attached.
You tried to set a number of characters that will not fit within the frame.
The upper thread has become tangled around the bobbin case, and the
needle is bent and hitting the needle plate, etc., so the sewing machine
stops (refer to page 178).
184