Error Messages - Baby Lock ellure plus BLR2 Instruction And Reference Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Error messages

When erroneous operations are performed messages and advice on operation will be displayed on the LCD.
Follow what is displayed. The message may disappear if the operation is performed correctly. The message will
disappear if
Error Message
is pressed while the message is displayed.
There is a possibility that the data for the selected pattern is corrupted.
Either the "Start/Stop" button or the "Reverse/Reinforcement Stitch"
button was pressed at a screen other than the sewing screen.
The "Start/Stop" button was pressed without connecting the foot
controller while the setting for adjusting the stitch width using the
sewing speed controller is set to "ON". You have selected a pattern for
which width control cannot be used.
The twin needle setting is selected while a pattern that cannot be sewn
with the twin needle is selected.
Upper thread broken.
Upper thread not set up correctly.
Upper thread has run out.
CAUTION
Be sure to rethread the machine. If you press the "Start/Stop" button
without rethreading the machine, the thread tension may be wrong or
the needle may break and cause injury.
The machine is deleting a previously saved pattern while in embroidery
edit mode.
The "Start/Stop" button was pressed while the foot controller was
connected. You tried to use the foot controller for embroidery.
While embroidering, data is written to the "Removable Disk" in the
connected computer or data is deleted from the "Removable Disk".
on the LCD was pressed when no card was inserted.
A stitch other than the buttonhole, bar tack or darning stitch was
selected and the "Start/Stop" button was pressed while the buttonhole
lever is lowered.
The buttonhole, bar tack or darning stitch was selected and the "Start/
Stop" button was pressed while the buttonhole lever is raised.
The "Start/Stop" button, "Reverse/Reinforcement Stitch" button or
"Thread Cutter" button was pressed while the presser foot was raised.
Probable Cause
Troubleshooting 183
5