Kyocera KX12 User Manual page 5

Hide thumbs Also See for KX12:
Table of Contents

Advertisement

Use with care
Use only in normal position (to ear). Avoid
dropping, hitting, bending, or sitting on the phone.
Keep phone dry
If the phone gets wet, turn the power off
immediately and contact your dealer. Water
damage may not be covered under warranty.
Resetting the phone
If the screen seems frozen and the keypad does
not respond to keypresses, reset the phone by
completing the following steps:
1. Remove the battery door.
2. Remove and replace the battery.
If the problem persists, return the phone to the
dealer for service.
Accessories
Use only Kyocera-approved accessories with
Kyocera phones. Use of any unauthorized
accessories may be dangerous and will invalidate
the phone warranty if said accessories cause
damage or a defect to the phone.
To shop online for phone accessories, visit
www.kyocera-wireless.com/store.
To order by phone, call 800-349-4188
(U.S.A. only) or 858-882-1410.
Radio Frequency (RF) energy
Your telephone is a radio transmitter and receiver.
When it is on, it receives and sends out RF energy.
Your service provider's network controls the power
of the RF signal. This power level can range from
0.006 to 0.6 watts.
User Guide for the Kyocera KX12 Phone
In August 1996, the U.S. Federal Communications
Commission (FCC) adopted RF exposure
guidelines with safety levels for hand-held wireless
phones. These guidelines are consistent with the
safety standards previously set by both U.S. and
international standards bodies in the
following reports:
ANSI C95.1 (American National Standards
Institute, 1992)
NCRP Report 86 (National Council on
Radiation Protection and Measurements,
1986)
ICNIRP (International Commission on Non-
Ionizing Radiation Protection, 1996)
Your phone complies with the standards set by
these reports and the FCC guidelines.
E911 mandates
Where service is available, this handset complies
with the Phase I and Phase II E911 Mandates
issued by the FCC.
Battery and charger specifications
Charger
Input
CV90-G2610
120 VAC / 60 Hz
CV90-K0261
100-240 VAC / 50 / 60Hz 4.5 V 600 mA
CV90-K0259-01
100-240 VAC / 50 / 60Hz 4.5 V 1.2 A
Extended Battery
CV90-N5001, 3.7V / 1800mAh
093 453 037
Output
5.2 VDC 400 mA
v

Advertisement

Table of Contents
loading

Table of Contents