Saw Blade - Honda HHT35S Owner's Manual

SAW BLADE

The U-type handlebar models are shipped with a manual nylon
cutting-line head installed on the trimmer. If the saw blade is needed,
move the ignition switch to the STOP (O) position and disconnect the
spark plug cap from the spark plug. Wear protective gloves when
working around the cutting-line head and saw blade.
Cutting-Line Head Removal
1. Align the gear case hole with the groove in cover plate/spacer A.
Insert a 4 mm hex wrench or equivalent into the gear case hole to
prevent the left-hand threaded output shaft from turning.
CUTTING-LINE HEAD
ASSEMBLY
SPACER B
COVER PLATE/
SPACER A
2. Hold the wrench and rotate the cutting-line head in the direction of
the arrow and remove the cutting-line head assembly.
Remove the cutting-line head as an assembly. Do not remove the
knob. Refer to page 19 for a cutting-line head assembly drawing.
Debris Shield Removal/Installation
1. Remove the cutting-line debris shield.
KNOB
(Do Not
Remove)
OUTPUT SHAFT
(left-hand thread)
5 x 28 mm
BOLT/WASHER (4)
SPACER (2)
[3/32" (2.3 mm) thick]
CUTTING-LINE
DEBRIS SHIELD
(with cutoff knife)
2. Install the brush/wood blade debris shield.
Tighten the bolt/washers:
TORQUE: 2.5 ft-lb (3.4 N·m, 0.34 kg-m)
BOLT/WASHER (4)
SPACER (2)
[3/32" (2.3 mm) thick]
BRUSH/WOOD BLADE
DEBRIS SHIELD
Saw Blade Installation
1. Insert a 4 mm hex wrench or equivalent into the gear case hole to
prevent the output shaft from turning.
2. Install cover plate/spacer A onto the output shaft as shown.
COVER
SPACER B
BLADE
Install with the white
markings facing the
debris shield.
BLADE
COVER
COVER PLATE/
SPACER A
3. With the blade cover installed on the blade, install the blade by
aligning the center of the blade with the shoulder on cover plate/
spacer A.
4. Install spacer B, the cover, and the 10 mm lock nut as shown.
Be sure to install the blade with the cutting edges of the saw teeth
in the direction of rotation; the side with the white markings must
face the debris shield.
The output shaft has left-hand threads. Tighten the 10 mm lock nut
counterclockwise.
TORQUE: 14 ft-lb (20 N•m, 2.0 kg-m)
5. Remove the 4 mm hex wrench or equivalent from the gear case.
5 x 28 mm
TIGHTEN
10 mm LOCK NUT
(left-hand thread)
OUTPUT SHAFT
(left-hand thread)
4 mm HEX TOOL
7