Blade Cover Removal; Blade Cover Installation - Honda HHT31S Owner's Manual

BLADE COVER REMOVAL

1. Turn the blade cover slowly until the
cover latch is clear of the debris shield.
Unfasten the latch by lifting the tab off
the post.
2. Pull the post end away from the blade
and set it on top of the blade as shown.
3. Turn the blade cover slowly until the post
end is clear of the debris shield, then
remove the blade cover from the blade.

BLADE COVER INSTALLATION

1. Install the blade cover over the blade so
half of the blade is covered.
To prevent the post end from interfering
with the debris shield, pull the post end
away from the blade and set it on top of
the blade as shown.
Turn the blade cover slowly until the post
end clears the debris shield.
2. Reposition the post end over the blade.
3. With the blade cover fully seated on the
blade, latch the tab over the post.
1
BLADE COVER
3
1
BLADE COVER
3
ASSEMBLY
POST
TAB
2
POST END
POST END
2
POST
TAB
POST END
POST END
47