Safety Label Locations; Recommended Cutting Attachments; Cutting-Line Heads And Shields - Honda HHT35S Owner's Manual

SAFETY LABEL LOCATIONS

The labels shown here contain important safety information. Please
read them carefully. These labels are considered permanent parts of
your trimmer/brush cutter. If a label comes off or becomes hard to
read, contact an authorized Honda servicing dealer for a replacement.
TYPE EQUIPPED WITH
U-TYPE HANDLEBAR
TYPE EQUIPPED WITH
LOOP HANDLE
RECOMMENDED CUTTING
ATTACHMENTS

CUTTING-LINE HEADS AND SHIELDS

A cutting-line head containing nylon monofilament line and a debris
shield with a cutoff knife is standard equipment. The shield's cutoff
knife automatically removes any excess line that is released from the
cutting head.
The U-type handlebar trimmers are supplied with two different debris
shields. Use the debris shield with the cutoff knife when the
cutting-line head is installed.
Nylon monofilament line is suitable for cutting grass and ordinary
weeds, but not brush and woody growth.
CUTTING-LINE HEAD
CUTOFF KNIFE
(inside the debris shield)
Manual-Feed Cutting-Line Head
Line is released from the cutting head by manually pulling and turning
the spool with the trimmer engine stopped.
HOUSING
Semi-Matic (bump-feed) Cutting-Line Head
Line is released from the cutting head by bumping the spool on hard
ground while the head is spinning. Do not tap the cutting-line head on
pavement or concrete.
HOUSING
NYLON MONOFILAMENT LINE
DEBRIS SHIELD
To release more line,
pull the spool and turn
it counterclockwise.
SPOOL
SPOOL
3