AWA LT20D User Manual page 8

Basic Remote Control Operation
16. S-STD Button
Whenever this button is pressed, the mode will be changed as follows.
17. P-STD Button
By pressing the P.STD button, sequentially select one of the 4 pre-sets
picture standard.
Standard : Select this mode to watch TV at standard state.
Dynamic : Select this mode to watch in a room with bright illumination.
Mild : Select this mode when the room is dark or to lessen eye fatigue.
User: Select this mode to view the picture to your set picture state preference.
18. Skip Button
1) It can used so that the unnecessary program number may not be displayed.
2) If you press this at a specific program number, OSD color of the current program
number will change from yellow to red.
3) If you want to watch the skipped program number, use 10 digit key to view it,
then press SKIP button, or operate AUTO PROGRAM in setup.
19. Program up( ) / down ( ) Button
1) It is used to select the channel you want to watch on either upward or downward direction.
2) It makes the cursor to move while in main MENU.
20. Volume up(+) / down (-) Button
1)It adjusts the volume level of sound.
2) It is used to choose a specified mode in the main MENU by pressing VOL(+) button.
3) It controls the increase or decrease of each mode you selected.
21. Exit Button
When you are satisfied with the settings, Press the EXIT Button repeatedly to return to
normal viewing
"&
Basic Remote Control Operation
22. Display Button
When TV mode displays the current channel number, picture mode, sound mode,
sleep and clock.
23. Q-view Button
Quick view for previous channel.
"'