Product Information Guide
INITIAL SYSTEM TEST
Power is applied to the control unit through a line cord plugged into a standard 110 V AC
outlet. A lighted green LED, visible in the upper left corner of the control unit, serves as the
POWER ON indicator. The control unit software checks all its common hardware
immediately after the powerup. At this point, test the CO lines and stations at the controller.
FEATURE TONES AND RINGING
Refer to User's Manual, Page 4, for information on distinctive ringing and the meaning of
various LED patterns.
Seven distinctive tones interact with system features:
1.
Intercom dial
2.
Central office dial
3.
Splash
4.
Busy
5.
Intercept or error
6.
Confirmation
7.
Manual signaling
Distinctive ringing allows you to identify:
1.
One ring as an inside or intercom call.
2.
Two rings as a call from outside the system.
3.
One short and one long ring as call transfer.
4.
Three rings as line reserve or returned transfer.
5.
One short, low volumn ring as incoming call when station is busy.
20
AT&T – PROPRIETARY
T217