Hitachi DB3DL Instruction Manual page 13

Cordless driver drill
Table of Contents

Advertisement

Available languages

Available languages

1. Insert the plug of battery charger into the receptacle.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger
as shown in Fig. 4.
3. Charging
When the battery is connected to the battery
charger, charging will commence and the
pilot lamp will light on.
NOTE: If the pilot lamp does not light, pull
out the plug from the receptacle and
check if the battery is properly
mounted.
When the battery is fully charged, the pilot
lamp will go out.
NOTE: The battery charging time becomes
longer when a temperature is low
or the voltage of the power source
is too low.
When the pilot lamp does not go off
even if more than four hour has
passed after start of the charging,
stop the charging and contact your
HITACHI AUTHORIZED SERVICE
CENTER.
Regarding the temperature of the rechargeable battery.
The temperatures for rechargeable batteries are as shown in the table below, and
batteries that have become hot should be cooled for a while before being recharged.
Rechargeable batteries
EBM315
WARNING:
Do not use the electrical cord if damaged. Have it repaired
immediately.
Table 2
Temperature at which the battery can be recharged
32°F — 122°F (0°C — 50°C)
Battery
Fig. 4
English
Pilot lump
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Db3dl - 3.6 volt lithium ion cordless screwdriver

Table of Contents