Electrolux EOG 6000 Instruction Booklet page 18

Replacement of gas grill
burner injector
To replace the gas grill burner injector, follow this proce-
dure:
2. Undo the two fixing screws ("A") which keep the oven
gas burner in place
3. Gently slide the gas grill burner off its slot and slowly
move it downwards, taking care not to cause stress
to the spark plug connection wire ("B") and the
thermocouple ("D") conductor;
3. With a 7 mm socket spanner unscrew and remove
the gas grill burner injector ("C"), and replace it with
the required one (see Table on this page);
4. Reassemble the burner following the same procedu-
re backwards.
The gas grill burner does not require any
primary air regulation.
Replacement of Gas Type Label
Once both the injectors for the gas oven burner and the
gas grill burner have been replaced, take the Gas Type
Label which is relevant to the new gas type and place it
over the old one (it is located near the gas connection
ramp). The replacement label is supplied with the injector
kit.
Gas Grill Burner Data
GAS INJECTOR
TYPE MARK
1/100 mm
Natural Gas
098
(G20)
LPG
71
(G30/G31)
NOMINAL NOMINAL GAS
GAS FLOW IN
POWER
3
(kW) m /h
1,9 0,181
1,9 -
B
REDUCED
GAS
POWER
g/h (kW)
- -
138 -
C D
BY-PASS NOMINAL
NEEDLE GAS
(1/100 mm) PRESSURE
(mbar)
- 20
- 28-30 / 37