Rear Panel - Galaxy DX 959 Owner's Manual

13. PA/GNF/CB SWITCH : In the "PA" position, your voice will come out
of the speaker that you need to plug in to the "PA. SP." jack on the back
of the radio. The radio does not operate when you are in the "PA" mode.
The "CB" mode is normal operation of the radio. In the "GNF" mode,
you are in CB operation but the Galaxy Noise Filter (GNF) is engaged.
This is a special noise filter that de-emphasizes audio high frequency
response in order to increase the signal-to-noise ratio of weak signals.
While you will notice a dramatic reduction in the "rushing" sound when
this filter is activated, it does not have much effect on the signal-to-noise
ratio of strong signals.
14. MODE SWITCH : This control allows you to select one of the
following operating modes: AM/USB/LSB.
15. TONE SWITCH HI/MED/LO : This switch changes the tone quality.
In LO position, bass is increased and in HI position, treble is increased.
16. CHANNEL DISPLAY : The channel display indicates the current
selected channel.
17. SWR ALERT LED : This LED lights red when your SWR is higher
than about 3:1. This is not an exact indicator of 3:1 SWR, but it is an
indication that you should check your SWR reading.
18. R.B. LED : This lights green when the Roger Beep is on.
19. RX/TX LED : This LED is green during receive and red during
transmit.
20. FREQUENCY COUNTER : This display indicates the frequency of
the selected channel.
- 9 -
REAR PANEL CONNECTOR
This device complies with part 15 of the FCC Rules.
Operation is subject to the condition that this device
does not cause harmful interference.
MODEL NO. : DX−959 FCC ID : M38 − DX − 959
AM / SSB 40 CH
CB TRANSCEIVER MADE IN MALAYSIA
70900001
DATE OF MFG.: SERIAL NO. :
1. ANTENNA : This jack accepts 50 ohms coaxial cable with a PL-259
type plug.
2. POWER : This accepts 13.8V DC power cable with built-in fuse. The
power cord provided with the radio has a black and red wire. The black
goes to negative and red goes to positive.
3. PA. SP. : This jack is for PA operation. Before operating, you must first
connect a PA speaker (8 ohms, 4W) to this jack.
4. EXT. SP : This jack accepts 4 to 8 ohms, 5 watts external speaker.
When the external speaker is connected to this jack, the built-in speaker
will be disabled.
1 3 4
2
- 10 -