Removing Expresscards - Fujitsu LifeBook T900 User Manual

Y
OU MAY BE REQUIRED TO LOG ON AS AN
G
ROUP TO COMPLETE THIS PROCEDURE
POLICY SETTINGS MAY ALSO PREVENT YOU FROM COMPLETING THIS PROCEDURE
1
See your ExpressCard manual for instructions on the installation of your card. Some cards may require that
your Tablet PC is off while installing them.
2
Make sure there is no ExpressCard currently in the slot. If there is, see Removing ExpressCards.
3
If the eject button is extended, press it until it clicks.
4
Insert the card into the slot with the label facing up.
5
Push the card firmly into the slot until it is seated in the connector.

Removing ExpressCards

See your ExpressCard manual for specific instructions on removing your card. Some cards may require
your Tablet PC to be in Sleep Mode or Off during removal.
•
W
INDOWS HAS A SHUTDOWN PROCEDURE FOR
REMOVING A CARD
IS GOOD PRACTICE TO REMOVE DEVICES USING
•
I
F THE DIALOG BOX STATES THAT THE DEVICE CANNOT BE REMOVED
OPEN FILES
1
Unlock the card from the slot by pressing the eject button associated with the slot in which the card is located.
When pressed, the button will pop out.
2
Firmly press the button again until it is flush with the Tablet PC. This will eject the card slightly out of the slot
allowing you to remove the card.
I E
F THE
REMOVING THE CARD
. (R
EVIEW YOUR OPERATING SYSTEM MANUAL FOR THE CORRECT PROCEDURE
,
CLOSE ANY OPEN APPLICATIONS AND SHUT DOWN YOUR
C
XPRESS ARD HAS AN EXTERNAL CONNECTOR AND CABLE
.
88 - ExpressCards
A
DMINISTRATOR OR MEMBER OF THE
. I
F THE COMPUTER IS CONNECTED TO A NETWORK
E C
XPRESS ARDS THAT MUST BE FOLLOWED BEFORE
S R H
AFELY EMOVE
,
A
DMINISTRATOR
,
NETWORK
.
ARDWARE IN THE SYSTEM TRAY
,
YOU MUST SAVE ALL OF YOUR
T PC.
ABLET
DO NOT PULL THE CABLE WHEN
'
S
.) I
T
.