Fujitsu LifeBook T900 User Manual page 49

Calibrating the Active Digitizer Display
In order to ensure accurate tracking between the stylus and cursor, you must run the Calibration Utility
before you use the system for the first time, or after you change the display resolution.
•
T
HE FIRST TIME YOU PERFORM A CALIBRATION
. S
MODE
•
T
HE FIRST TIME YOU CALIBRATE
WILL REQUIRE ONLY FOUR CALIBRATION POINTS
To run the calibration utility:
1
Go to Start -> Control Panel. (On Windows Vista systems, If you are not in Classic View, select "Switch to
Classic View" in the left panel.)
2
Double-click the Tablet PC Settings icon and select the General tab. (In Windows 7, click Hardware and Sound,
then select Tablet and PC Settings.)
3
Click the [Calibrate] button.
4
Adjust the display of your Tablet PC to a comfortable angle and find the (+) symbol in the upper-left corner of
the display.
D
O NOT USE EXCESSIVE FORCE WHEN TAPPING ON THE SCREEN DURING CALIBRATION
EXCESSIVE FORCE COULD RESULT IN DAMAGE TO THE
5
Using the stylus, firmly touch the screen directly on the (+) symbol. Lift the stylus from the screen and the target
will move to a different location on the screen.
6
Repeat step 4 until you have selected all of the (+) symbols.
7
Once you have selected all the symbols, press the [OK] button.
8
Touch the stylus to various points on the screen to verify that the screen is correctly calibrated. If you are not
satisfied with the screen's calibration, press the [Calibrate]) button to begin again.
UBSEQUENT CALIBRATIONS CAN BE PERFORMED IN LANDSCAPE OR PORTRAIT MODE
,
THERE WILL BE
49 - Touchpad/Active Digitizer/Touchscreen
,
THE SYSTEM DISPLAY SHOULD BE IN LANDSCAPE
16 ;
CALIBRATION POINTS SUBSEQUENT CALIBRATIONS
.
LED /
AND OR TOUCH PANEL
.
. U
SE OF
.