Burner Flame Check And How To Re-Ignite Burner; Turning Off Cooker And Disconnecting Hose - Bayou Classic SP10 Owner's Manual

Model #SP1 Jet Cooker - BURNER FLAME CHECK
When lighting for the first time, you will smell paint burning at the top of the cooker for a few minutes...
This is normal.
WARNING
In bright sunlight the flame may appear invisible. DO NOT lean over the cooker during use.
DO NOT wear loose clothing or allow long hair to hang freely while lighting or using the cooker.
The regulator valve controls flame intensity. Practicing adjusting
flame height up and down. You will notice that this cooker
emits a loud JET sound, hence the name Jet Cooker.
HOW TO REIGNITE Model #SP1 Jet Cooker
If burner flame does NOT ignite immediately, or is accidentally
extinguished, turn LP Gas Cylinder Valve clockwise to OFF.
Then turn regulator valve clockwise to OFF position.
Wait 5 minutes for gas to evacuate before re-lighting, then repeat
steps 1-7 to re-light. Always use caution when re-lighting as cooker frame
and cooking vessel will be hot.
If the cooker does not light within the first few attempts, there is a problem with the gas supply.
Turn off the gas at the cylinder and regulator. DO NOT attempt to operate the cooker until the problem
is found and corrected. Refer to Troubleshooting on Pages 30 - 31.
TURNING OFF JET COOKER AND DISCONNECTING HOSE FOR Model #SP1
NOTE: Turn off LP gas cylinder valve first to prevent gas from being left in the regulator hose system
under pressure.
1. Turn OFF the LP gas cylinder valve clockwise until it stops.
2. Turn regulator valve to the OFF position, clockwise until it stops.
3. To disconnect Regulator Hose Assembly, turn the large coupling nut counter-clockwise by hand.
1
Turn OFF
LP Cylinder.
Close Valve Fully
The LP gas cylinder valve should always be in the OFF or closed position when the cooker is not in use.
FOR YOUR SAFETY:
2
Turn OFF Regulator.
Close Valve Fully
19
ADJUST Regulator Valve
for Flame Height
3
Turn COUNTER-CLOCKWISE
to Disconnect
Disconnect
Regulator