Burner Flame Check - Bayou Classic SP31 Owner's Manual

6
7

BURNER FLAME CHECK

Adjust flame height using regulator valve. Rotate air control shutter to achieve mostly blue flame.
The air control shutter mounted on the front of burner helps to control the amount of air that mixes
with the LP gas. A blue flame with little or no yellow flame indicates a proper air/gas mixture
and provides the best heat. Adjust the air control shutter until the desired flame is achieved.
NOTE: Make sure the brass fitting on hose is screwed into the burner/air shutter and tightened
securely. Do not over-tighten as the air shutter needs to move freely in order to adjust air intake.
Check the attachment for proper connection everytime propane tank is connected to cooker.
HINT: Before lighting, turn air control shutter on the burner to an almost closed position. This increases the gas portion of the air/gas
mixture and makes the burner easier to light. After lighting, turn air control shutter to an open position to achieve a better flame.
If burner flame does NOT ignite immediately, or is accidentally extinguished, turn LP Gas Cylinder Valve clockwise to OFF. Then
turn regulator valve clockwise to OFF position. Wait 5 minutes for gas to evacuate before re-lighting, then repeat steps 1- 4 to
re-light. Always use caution when re-lighting as cooker frame and cooking vessel will be hot.
If the burner does not light within the first few attempts, there is a problem with the gas supply. Turn off the gas at the cylinder and
regulator. DO NOT attempt to operate the cooker until the problem is found and corrected. Refer to Troubleshooting on Pages 16 - 17.
HOW TO REIGNITE
Follow steps 1 - 4 on previous page, to reignite burner. Use caution when re-lighting the burner, as hot oil from cooking vessel
may have splattered and run down the sides of the unit creating a slick surface. Use caution not to touch the cooker or cooking
vessel when re-lighting the burner.
TURNING OFF COOKER AND DISCONNECTING HOSE
NOTE: Turn off LP gas cylinder valve first to prevent gas from being left in the regulator hose system under pressure.
1. Turn OFF the LP gas cylinder valve clockwise until it stops.
2. Turn regulator valve to the OFF position, clockwise until it stops.
3. To disconnect Regulator Hose Assembly, turn the large coupling nut counter-clockwise by hand.
1
Turn OFF
LP Cylinder.
Close Valve Fully
WARNING
The LP gas cylinder valve must always be in the OFF or closed position when the cooker is not in use.
Adjust the regulator valve for the desired flame height.
NOTE: The regulator control knob controls flame intensity only.
It is not an ON/OFF valve. Practice rotating the regulator
control knob to become familiar with flame adjustment.
Your burner has an air control shutter, rotate the shutter until a blue flame is
achieved. In direct sunlight, flame may appear clear. If the air shutter is tightened
and will not utrn. Turn OFF the burner and loosen screws enough to turn the air
shutter and it will hold its position. Once ideal flame has been established, you
can tighten the screws fully. WARNING: never adjust a hot burner. Only adjust
when it is OFF and cool to touch.
2
Turn OFF Regulator.
Close Valve Fully
3
Disconnect
Regulator
15
ORANGE
BURNER
FLAME
BLUE
CORRECT INCORRECT
Turn COUNTER-CLOCKWISE
to Disconnect