Connecting Cabletv - Samsung LN-T4669FX - 46" LCD TV Owner's Instructions Manual

Connecting Cable TV
To connect to a cable TV system, follow the instructions below.
Cable without a Cable Box
t. Plug the incomingcable into the ANT 2 IN (CABLE) terminal on the back of the TV.
Because thisTV is cable-ready, you donotneeda cableboxtoviewunscrambled c ablechannels.
Connectinqto a Cable Box that Descrambles All Channels
t. Find the cable that is connected to the ANT OUT terminal on your cable box.
Thisterminalmightbe labeled"ANTOUT","VHFOUT"or simply,"OUT".
2. Connect the other end of this cableto the ANT 2 IN (CABLE) terminal on the back of the TV.
Connectin_to a Cable Box that Descrambles Some Channels
If your cable box descrambles only some channels (such as premium channels), fotow the instructions below. You will need a two-
way splitter, an RF (A/B) switch and four lengths of RF cable. (These items are available at most electronics stores.)
Find and disconnect the cable that is
connected to the ANT IN terminal on your
cable box.
This terminal m ightbe labeled"ANTIN",
"VHFIN"or simply,"IN"
2, Connect this cable to a two-way splitter.
3=
4=
Connect an RF cable between the OUTPUT
terminal on the splitter and the IN terminal
on the cable box.
Connect an RF cable between the
ANT OUT terminal on the cable box and
the B-IN terminal on the RF(A/B) switch.
........... ..L.
incoming
cable
Splitter
Incoming
cable
incoming
cable
RF (A/B)
Cable Box Switch
5=
Connect another cable between the other
OUT terminal on the splitter and the A-IN
terminal on the RF (A/B) switch.
Sphtte cable -_r h RF_/ )(A/B
Cable Box Switch
6=
Connect the tast RF cable between the
OUT terminal on the RF (A/B) switch and
the ANT 2 IN (CABLE) terminal on the rear
of the TV.
ANT 2 iN
cable . i
Sp,tte, L J
RF(A_BI
Cable Box Switch
After you have made this connection, set the A/B switch to the "A" position for normal viewing. Set the A/B switch to the "B" position to
view scrambled channels. (When you set the A/B switchto "B", you will need to tune your TV to the cable box's output channel, which is
usually channel 3 or 4.)