Table of Contents
Advertisement
I. Introduction of
Vehicle Functions
Steering wheel lock/ignition
switch
Combined steering wheel lock/ignition
switch has the following key positions:
"B"
–Ignition switch turns off and the
steering wheel is blocked.
When the key is pulled out from the
ignition switch, the steering wheel lock
acts and t he steering wheel is blocked.
To lock the steering wheel, it shall turn it
Operation & Adjustment of Inside Devices
after the key is pulled out till a click of
blocking is heard.
"I"–unlock the steering system. The circuit
of electric accessories is connected and
small electric appliance such as inside
lights can be operated. But the ignition
switch
and
main
electric
disconnected.
If the key could not or is difficult turn to
the position from "B", slightly turning the
steering wheel and then the locking system
of steering wheel may loosen.
The ignition switch key shall not be placed
at the position too long to avoid the power
of battery running out of.
"II"–Connect the ignition circuit. All
electric loops can work. Alarm lamps and
indicator lamps light. It is the normal
position of key during driving and the
position that must be selected for towing
the vehicle.
"III"
–Connect the motor and start the
engine. When the lock hole is at the
position,
headlamps
and
equipment that consume more power will
be disconnected fully.
The ignition switch is equipped with
anti-repeatable start device inside. Once
the engine runs, the device may prevent
mis-start of engine, so that it avoids
damage from the engine and flywheel.
If the engine does not start, the key must be
loop
are
turned to "B" before restart, and then
turned to the position. After start, release
the key and it will return to "II" position.
Once the engine started, the
key must be released. DO NOT
remain at "III" position for a long
time.
electrical
28
Advertisement
Table of Contents
